Setting the Pass/Fail Limits

The measurement limits setting enables you to alter the value of the maximum and minimum test limits for the Average Insertion Loss measurement. Limits are set in dB. These settings affect the metrics color display: red represents fail, green represents pass. Next to the displayed measurement value, a (P) indicating Pass, or (F) indicating Fail, will be shown to further indicate whether the value is within or outside the set limits.
To Set the Measurement Maximum and Minimum Limits:

Step
 		Notes
1
 		[Setup]
2
 		[Limits]

3
 		On [Limits] select On or Off.
Enables you to toggle the measurement limits function On (active) and Off (inactive).
  • If set to On, Any measured value that exceeds the upper maximum or is less than the minimum limit will result in a failure indication for that value.
  • If set to Off, pass fail indicators seen in the metrics display portion of the display will not be displayed.
4
 		Set the upper limit.
  1. [Maximum Limit]
  2. Enter the number on the numeric keypad.
  3. [dB]
Maximum limit can be set from -100 to 100 dBm.
5
 		Set the lower limit.
  1. [Minimum Limit]
  2. Enter the number on the numeric keypad.
  3. [dB]
Maximum limit can be set from -100 to 100 dBm.