Using Restart

Using Restart
When you have averaging turned on, you can restart the averaging by pressing the Restart menu key. This restarts the averaging for running average in either Continuous or Single sweep mode.
To restart averaging:

Step
Notes

1
[Average/Sweep]

2
[Restart]
This key is unavailable or has no effect when Sweep is set to Single. To restart a Single Sweep measurement, press [Single].
It is worth noting that there are some other events that automatically cause a restart. These events are:
If the analyzer identifies a change in PN Offset.
If you enter a new PN Offset value.
If the PN Offset State is changed to Auto or to Manual.
If you change the X-scale from MAC to Walsh Code, or from Walsh Code to MAC.
If you change the Measurement Time.
If you change the CDP Type.


	Step	Notes
1	[Average/Sweep]
2	[Restart]	This key is unavailable or has no effect when Sweep is set to Single. To restart a Single Sweep measurement, press [Single]. It is worth noting that there are some other events that automatically cause a restart. These events are: If the analyzer identifies a change in PN Offset. If you enter a new PN Offset value. If the PN Offset State is changed to Auto or to Manual. If you change the X-scale from MAC to Walsh Code, or from Walsh Code to MAC. If you change the Measurement Time. If you change the CDP Type.