Setting the Measurement Frequency Error Limits


Step
 		Notes
1
 		[Setup]
2
 		[More 1 of 2]

3
 		[Limits]

4
 		On [Freq Error Limits] select On or Off.
Enables you to toggle the measurement limits function On (active) and Off (inactive).
  • If set to On, the Frequency Error will change from blue to red (fail) or green (pass) and indicate either a "P" (pass) or "F" (fail). If the measured value exceed either the upper or lower limit, ALL PASS, in the bar at the bottom of the screen, will change to FAILURE.
  • If set to Off, the channel freq/number value will be displayed in blue. The area at the bottom of the screen that is used to indicate Pass or Fail will be over-written. The bar at the bottom of the screen, will indicate measurement in progress.
5
 		Set the upper limit.
  1. [High Limit]
  2. Enter the number on the numeric keypad.
  3. [GHz], [MHz], [kHz], or [Hz]

6
 		Set the lower limit.
  1. [Low Limit]
  2. Enter the number on the numeric keypad.
  3. [GHz], [MHz], [kHz], or [Hz]