Setting the Stop Frequency/Channel

Setting the Stop Frequency/Channel
The Stop Frequency or Stop Channel sets the end frequency (or channel) to which the analyzer will scan. You can specify either a Stop Frequency or a Stop Channel, depending on your Units setting. This is described in "Setting the Units of Measure for the Graphical Display"
To Set the Stop Frequency or the Stop Channel:

Step
Notes

1
[Stop Freq] or [Stop Chan]
This choice depends on the [Units] mode you are using.

2
Enter the desired channel or frequency step using the numeric keypad.

3
[Enter]
OR
[Hz], [kHz], [MHz], or [GHz]
This choice depends on the [Units] mode you are using. When specifying channel numbers, terminate your selection with [Up] or [Dn] to specify either an Uplink Channel or Downlink Channel.
When specifying a frequency, terminate your selection with one of the frequency units of measure.
Notice (and verify) that the number you entered appears below the Stop Freq or Stop Chan text on the corresponding button.


	Step	Notes
1	[Stop Freq] or [Stop Chan]	This choice depends on the [Units] mode you are using.
2	Enter the desired channel or frequency step using the numeric keypad.
3	[Enter] OR [Hz], [kHz], [MHz], or [GHz]	This choice depends on the [Units] mode you are using. When specifying channel numbers, terminate your selection with [Up] or [Dn] to specify either an Uplink Channel or Downlink Channel. When specifying a frequency, terminate your selection with one of the frequency units of measure. Notice (and verify) that the number you entered appears below the Stop Freq or Stop Chan text on the corresponding button.