Setting the Channel Standard

Setting the Channel Standard
You can specify one of the recognized GSM or EDGE standards for your measurements.
When you select your Channel Standard, the Start and Stop channels are automatically set to valid channels within the selected band only if your Units are set to Chan. If your Units are set to Freq, the Start and Stop Frequencies will not change from your current settings. For details on setting Units, see "Setting the Units of Measure for the Graphical Display"
To Set the Channel Standard:

Step
Notes

1
[Chan Std]
This displays a list of the pre-loaded channel standards.

2
Highlight the Channel Standard you want.
Use the Up and the Down arrows, or the knob, to navigate to the standard you want. Note that some standards might be off the top or the bottom of the screen.

3
[Select]


	Step	Notes
1	[Chan Std]	This displays a list of the pre-loaded channel standards.
2	Highlight the Channel Standard you want.	Use the Up and the Down arrows, or the knob, to navigate to the standard you want. Note that some standards might be off the top or the bottom of the screen.
3	[Select]