Setting the Display Position

Setting the Display Position
You can set the location or position of the channel of interest. This determines the channel used to calculate the measurement metrics displayed in the metrics portion of the display. It also determines the center frequency in Spectrum View, and the channel from where slot information is displayed in the Power versus Time view.
In the Channel Scanner view only, the channel of interest is indicated by vertical yellow line.
To Set the Display Position:

Step
Notes

1
[Display]

2
[Position]

3
Enter the desired channel number or frequency using the numeric keypad, the up and down arrows, or the knob.

4
If Frequency/Channel Units have been set to Chan, select [Up] or [Dn]
If Frequency/Channel Units have been set to Freq, select [Hz], [kHz], [MHz], or [GHz]
If you use the up and down arrows or knob to change the channel number/frequency, the terminator units keys will not be displayed. However, the display will update to the entered number of bars after a few seconds.


	Step	Notes
1	[Display]
2	[Position]
3	Enter the desired channel number or frequency using the numeric keypad, the up and down arrows, or the knob.
4	If Frequency/Channel Units have been set to Chan, select [Up] or [Dn] If Frequency/Channel Units have been set to Freq, select [Hz], [kHz], [MHz], or [GHz]	If you use the up and down arrows or knob to change the channel number/frequency, the terminator units keys will not be displayed. However, the display will update to the entered number of bars after a few seconds.