Setting the RMS Phase Error Limit

You can set an upper RMS Phase Error Limit for your Measurement results.
 If RMS Ph Err Limit is turned On, and your measured RMS Phase Error is below the limit you have specified, the numeric results reported in the metrics portion of the screen will be displayed in green, and the Limit Pass will be indicated by "(P)" after the result. If your measured RMS Phase Error is above your specified limit, the numeric result reported in the metrics portion of the screen will be displayed in red, and the Limit Failure will be indicated by "(F)" after the results.
 To Set the RMS Phase Error Limit:

Step
 		Notes
1
 		[Setup]
2
 		[RMS Ph Err Limits]

3
 		[Limits]

4
 		[On] or [Off]
5
 		Set the high limit.
  1. [High Limit]
  2. Enter the number on the numeric keypad.
  3. [deg]