Adding or Deleting a List Item

Adding or Deleting a List Item
You may add and delete list items from the Scan Mode List for the specific channel/frequencies you want to measure.

NOTE: If you duplicate a channel entry in your list, you might notice that the graphical results for the duplicated channel vary. This is because the analyzer takes a separate acquisition of data for each of the channel plots. The variance you see in the displayed plots are due to the signal's variance over time from one acquisition to the next.

To Add or Delete a List Item:

Step
Notes

1
Enter channels into the list.

Use [Insert Row] to add a channel. First highlight a row, then use [Insert Row] to insert a row below the highlighted row. Then enter its number using the numeric keypad and [Up] or [Dn] to complete each entry.
Use [Delete Row] to remove channels you do not want displayed. Select a channel you want to remove using the up and down arrow buttons. Then press [Delete Row] to remove the selected channel.
[Ok]
The maximum number of list items is 40. If the number of channels displayed is 20 or fewer, a single bar graph is used to display them.
If the number of channels displayed is greater than 20, two bar graphs are used to display them. Half of your selected channels are shown in a horizontal bar graph displayed in the upper portion of the screen, and the remaining channels are shown similarly in the lower portion of the screen.


	Step	Notes
1	Enter channels into the list. Use [Insert Row] to add a channel. First highlight a row, then use [Insert Row] to insert a row below the highlighted row. Then enter its number using the numeric keypad and [Up] or [Dn] to complete each entry. Use [Delete Row] to remove channels you do not want displayed. Select a channel you want to remove using the up and down arrow buttons. Then press [Delete Row] to remove the selected channel. [Ok]	The maximum number of list items is 40. If the number of channels displayed is 20 or fewer, a single bar graph is used to display them. If the number of channels displayed is greater than 20, two bar graphs are used to display them. Half of your selected channels are shown in a horizontal bar graph displayed in the upper portion of the screen, and the remaining channels are shown similarly in the lower portion of the screen.