Persistent Signal Generator

Persistent Signal Generator
The signal generator function can be used simultaneously with other measurement functions of the test set. This allows you to use the test set as both the source and the measurement device when making your measurements. To do this, setup the signal generator as described in "Performing a Basic Signal Generator Measurement"
Then proceed as described below.

Step
Notes

1
Mode

2
[Spectrum Analyzer/Tools]

3
[Signal Generator]

4
[Freq/Chan/Time Ref]

5
On [Persist Sig Gen] select Yes.
Each time you press this softkey, the selected option changes.
Yes turns the persistent signal generator function On and No turns the function Off. When the persistent signal generator is turned On, an icon appears in the lower-right corner of the display.

6
Mode

7
Select the desired measurement mode and proceed with your measurements

17
[Amplitude]
Changes the RF output power. Amplitude becomes the active function and the current value is shown in the active entry area of the display. To enter a new value for amplitude, turn the rotary knob until the desired value is displayed, use the up and down arrow keys, or enter the value using the numeric keypad. Then press [dBm].


	Step	Notes
1	Mode
2	[Spectrum Analyzer/Tools]
3	[Signal Generator]
4	[Freq/Chan/Time Ref]
5	On [Persist Sig Gen] select Yes.	Each time you press this softkey, the selected option changes. Yes turns the persistent signal generator function On and No turns the function Off. When the persistent signal generator is turned On, an icon appears in the lower-right corner of the display.
6	Mode
7	Select the desired measurement mode and proceed with your measurements
17	[Amplitude]	Changes the RF output power. Amplitude becomes the active function and the current value is shown in the active entry area of the display. To enter a new value for amplitude, turn the rotary knob until the desired value is displayed, use the up and down arrow keys, or enter the value using the numeric keypad. Then press [dBm].