Auto Configuration Flow
Selecting Auto Config causes the test set to analyze the incoming T1 signal and align the setup choices to that signal. If the incoming data pattern is not recognized then "NA Live Data" is displayed and the pattern selected on the setup screen will remain unchanged. If B8ZS codes are detected then this condition will be indicated and the line code parameter will be set accordingly. If setup was configured for B8ZS prior to selecting Auto Config and the pattern detected does not have sufficient zeros density to warrant B8ZS then "NA" will be displayed and the line code choice in the setup screen will remain unchanged. Finally, the framing format is detected, displayed and selection changed accordingly on the setup screen.
Refer to the Measurement Guide for the following flow diagrams:
- In-band loop-up code originating from the test set
- In-band loop-down code originating from the test set
- Out-of-band loop-up code originating from the test set
- Out-of-band loop-down code originating from the test set
- Auto configuration