Setting the PICH Parameters

Setting the PICH Parameters
The PICH (Paging Indicator Channel) Setting allows you enable PICH and designate the channel number. The PICH settings help the test set to determine which channel is the PICH channel. Once the test set has identified this channel, it can perform the delta power measurements for this channel and display them to you.

Step
Notes

1
[Setup]

2
[PICH]
This key displays the current Spread Factor, selected channel (in parenthesis), and Enable /Disable status.

3
On [PICH Enable] select On or Off.
Each time you press this softkey, the selected option changes.
[Spread Factor] is grayed out and unavailable because the spread factor is fixed at 256.

4
Set the channel.

[Channel]
Enter the channel number using the numeric keypad.
[Enter]
Always enter the channel number even if you have set Units to Freq.


	Step	Notes
1	[Setup]
2	[PICH]	This key displays the current Spread Factor, selected channel (in parenthesis), and Enable /Disable status.
3	On [PICH Enable] select On or Off.	Each time you press this softkey, the selected option changes. [Spread Factor] is grayed out and unavailable because the spread factor is fixed at 256.
4	Set the channel. [Channel] Enter the channel number using the numeric keypad. [Enter]	Always enter the channel number even if you have set Units to Freq.